Cleaner, brighter pool decks for Lakeside homes
Pool Deck Paver Sealing in Lakeside, FL
Call (904) 606-1548 for a free estimate on sealing the pavers around your Lakeside pool.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my Lakeside pool deck pavers sealed, and how soon?
A local contractor can seal the pavers around your Lakeside pool, and a reply reaches you within 1 business day, often well before that. The visit and the written estimate are free, and nothing obliges you to book. Mention whether the deck sits inside a screen cage, under oak branches or in open sun. To get started, call (904) 606-1548.
A pool deck is the paved area people use most from spring through fall, so it shows wear first. Splash water, sunscreen and bare feet leave the joints dark and the surface dull, and a shaded corner can turn green. A fresh coat brings the color back and makes the deck easier to rinse. To ask about a date, get a free estimate.
Which neighborhoods near Lakeside can get pool deck estimates?
A local contractor works across Clay County and into the towns on the other side of Doctors Lake and the river it drains to. Every town in the list below has its own page with notes for that area, and the pool deck guidance here applies to all of them. If your street is not listed, call (904) 606-1548.
What does sealing do for a pool deck?
Sealing is the protective step that follows washing and re-sanding, and a pool deck gets more out of it than most paved areas. Splash, sunscreen and standing damp are the problems it is meant to slow down. To see which benefits matter for your deck, call (904) 606-1548.
Moisture and mildew resistance
Unilock lists pool decks among the areas that gain added resistance to moisture and mildew, especially where splash and sunscreen are common.
Joint sand stays put
Sealer tightens the top of the sand joints, which leaves fewer places for seeds to settle and helps the sand hold through summer downpours.
Color that holds
A wet look deepens the shade of the paver, while a natural finish stays close to the unsealed look. Either one resists fading from sun better than bare pavers.
A deck that rinses clean
Dirt and oils sit on top of a sealed surface instead of soaking in, so a gentle rinse and sweep keeps the deck looking cared for.
Will a sealed pool deck be slippery in Lakeside?
It does not have to be. The finish decides how a deck feels when wet, so this is the first question to settle with a contractor. Unilock says high gloss sealers can look great but may turn slick when wet, while a penetrating matte sealer keeps the texture and traction of the paver. Ask for the finish name and a sample patch before you get a free estimate.
Wet feet are the test that counts. Kids run on pool decks, and a deck with a coat that holds water on top can feel different from the bare paver it replaced. Ask the contractor to wet a small test spot and let you walk on it. To arrange that visit, call (904) 606-1548.
How do oaks, screen cages and Doctors Lake air affect a pool deck here?
Lakeside covers about 15.7 square miles, and Wikipedia puts 13.96 percent of it under water. Doctors Lake, a brackish estuary of about 13 square miles, lies along the east side, so the air carries moisture through most of the year. A pool deck under a cage and an oak canopy dries slowly, which means algae gets a longer growing season. To have a deck checked, call (904) 606-1548.
A First Coast washing company also lists oak tannin stains as a common problem on pool decks and says sealer helps keep a stain from setting in the next season. Leaves that sit on a wet deck leave brown marks, and cage screens collect pollen that rain then carries onto the pavers. If your deck lies under branches, get a free estimate.
How hot can the pavers be when sealer goes down?
Pool decks sit in full sun, which makes the surface temperature a real planning issue. Western Interlock says sealer may not work properly when the paver surface passes 90 degrees, and pavers in direct sun can pass 90 even when the air is near 75. The same source suggests keeping the surface under 90 for about two hours after the coat goes down. To pick a cooler window for your deck, call (904) 606-1548.
Unilock gives a wider air range of 50 to 90 degrees, with 75 as the ideal. In practice that points to cooler mornings or shaded hours, and to skipping a day when storms are forecast. Ask the contractor how the surface temperature will be checked, and bring up the cage and the oak shade when you get a free estimate.
Is the pool deck dry enough to seal after a Lakeside rain?
Often it is not, and that is where jobs go wrong. Western Interlock warns that hidden moisture in the joints or the bedding stops sealer from bonding and leaves cloudy, foggy spots. Its moisture check is to tape plastic sheeting over a square of the surface, and if no condensation forms, the pavers are dry. A contractor can do that test before spraying. To ask how it would be handled on your deck, call (904) 606-1548.
Unilock adds that pavers can be dry in a few hours in warm sun but need about 24 hours in cool shade after washing, with 24 to 48 hours of clear skies beforehand. The pool and a cage keep a deck damp, so the shaded side may need the longer wait. Plan around the forecast when you get a free estimate.
How does the pool deck sealing process work?
The process runs in a set order, and the pool shapes each step. A contractor has to protect the water, the screen and the plants before any cleaner or sealer is applied. To see how the visit would run at your home, call (904) 606-1548.
1. Walk the deck
The contractor checks for algae, sunken sections, stains, old sealer and the way water drains off the surface. Sealing does not fix poor drainage, so that is noted first.
2. Cover and protect
Plants, the screen mesh, the pool edge and equipment are covered or shielded so cleaner and sealer stay on the pavers.
3. Wash and treat
Algae, mildew and grime come off in a careful wash, the same kind of prep one Tampa area pool patio job lists for its mold, mildew and algae.
4. Fill the joints
Joint sand is swept in and packed. If polymeric sand is used, Unilock says it needs about 24 hours to dry and any residue must be swept from the surface before sealing.
5. Seal and hold off
The coat is sprayed on and rolled out in one session. The deck then stays closed while it cures, with sprinklers turned off.
What does pool deck paver sealing cost in Lakeside?
One First Coast company lists $1.75 to $3.25 per square foot to clean, re-sand and seal paver decks and drives. No page found gave a separate pool deck only rate, so the table applies that range to common deck sizes. A contractor sets the real number after looking at your deck. To get it, get a free estimate.
What moves the price is how much work comes before the coat. Deep algae, sunken pavers and a failed old coat take more labor, and a First Coast washing company says a failed coat has to be stripped before new sealer, which turns the job into a two day restoration. Splash zones around steps and the cage edge take careful masking. For a price on your own deck, call (904) 606-1548.
| Pool deck | Typical Lakeside layout | Clean, sand and seal |
|---|---|---|
| 400 sq ft | Small deck or spa surround | $700 to $1,300 |
| 700 sq ft | Deck inside a screen cage | $1,225 to $2,275 |
| 1,000 sq ft | Wraparound deck with a seating corner | $1,750 to $3,250 |
| 1,400 sq ft | Pool deck plus a lanai and outdoor kitchen pad | $2,450 to $4,550 |
Math based on the $1.75 to $3.25 per square foot that a First Coast paver company published for paver decks and drives. Joint sand, repairs and stripping are usually priced apart.
How long does sealer last on a pool deck?
Expect two to three years. A First Coast washing company calls that typical and says full sun, pool chlorine and summer storms can push it toward two. Unilock and Nicolock both put the general range for sealed pavers at three to five years, which shows why a pool deck sits at the short end. To plan a schedule, call (904) 606-1548.
Western Interlock offers a simple water check. Water that beads for five minutes or more means the sealer still works, and water that soaks in within one to two minutes means a new coat should come within six months. If you can name the spot that darkens first, tell the contractor when you get a free estimate.
What do sealed pool decks look like around Lakeside?
What should I ask a pool deck sealing contractor?
A few questions tell you more than any price can. Ask which sealer finish will be used and how it feels when wet, how the screen and pool edge are protected, and how the contractor tests that the pavers are dry. Ask who handles a stain that comes back. For help comparing answers, call (904) 606-1548.
Also ask what happens if it rains after the coat goes on. Unilock asks for up to 48 hours of dry weather afterward, so a storm may mean a return visit. The written estimate should list the product name and what happens in that case. To request one, get a free estimate.
What do Lakeside homeowners ask about pool deck sealing?
How much to seal a pool deck?
A First Coast company publishes $1.75 to $3.25 per square foot to clean, re-sand and seal paver decks and drives. For a 700 square foot Lakeside pool deck that works out to about $1,225 to $2,275. Stripping an old coat or resetting sunken pavers is priced on top.
Is it good to seal pavers in Florida?
For a pool deck, usually yes. Unilock says sealing adds resistance to moisture and mildew where splash and sunscreen are common. The coat wears, so plan on a fresh one every few years, and ask for a finish that grips when wet.
Is it better to spray or roll paver sealer?
Many contractors use both. Unilock suggests spraying the product on and then running a dry roller over it to lift off the excess, all in one session. Near a screen cage, ask how overspray is kept off the mesh and the lanai door.
Why is paver sealing so expensive?
Most of the price is prep and waiting. The deck is washed, the joints get new sand, and everything has to dry before the coat goes on. A pool deck adds masking around the pool edge, the cage and the equipment, which takes time.
Will a sealed pool deck be slippery in Lakeside?
It depends on the finish. Unilock notes that high gloss sealers can turn slippery when wet, while a penetrating matte sealer keeps the texture of the paver. Ask the contractor to describe the finish and how it feels under wet bare feet.
Can I use my pool right after the deck is sealed?
Not right away. Unilock asks for up to 48 hours of dry weather for the coat to cure, and Nicolock says to wait at least 24 hours before walking on it or setting furniture back. The contractor can give you a time for your product.
Do I need to turn off my sprinklers before the deck is sealed?
Yes. Unilock says water from automatic sprinklers can leave white marks or get trapped under the sealer. Tell the contractor which zones reach the deck and when they run.
Does pool chemistry shorten how long sealer lasts?
A First Coast washing company says full sun, pool chlorine and summer storms can pull the usual two to three years down toward two. A yearly look at the deck helps catch wear before the coat fails.
What other paver services are available in Lakeside?
A pool deck is often one of several paved areas at a home. The pages below cover the rest, and each can be priced on its own or together. To plan which areas go first, call (904) 606-1548.
Ready to get the pool deck ready for summer?
Send the short form or call, and a local contractor replies within 1 business day, usually much sooner.
Free, no obligation